3.0mm (1.2") 8×8 Blue Dot LED Matrix Display Common Cathode Luminous Intensity

3.0mm (1.2") 8×8 Blue Dot Matrix LED Displays Common Cathode luminous intensity

DL-D30881XBB.pdf

Features:

1. 1.2inch (32.00mm) Matrix height.
2. Colors: Super Bright Blue.
3. Flat package and light weight.
4. Easy assembly.
5. High quality and low cost.
6. High reliable and intensity.
7. Low power requirement.
8. The product itself will remain within RoHS compliant version.

Descriptions:

1. The DL-D30881 series is a large emitting area (3.0mm diameter) LED sources configured in a 64 dots 8*8 matrix array.
2. These displays provide excellent reliability in bright ambient light.
3. These devices are made with white dots and black surface.

Applications:

1. Audio equipment.
2. Instrument panels.
3. Digital read out display.

Device Selection Guide:

Absolute Maximum Ratings at Ta=25℃

Electrical Optical Characteristics at Ta=25℃

Notes:
1. Luminous intensity is measured with a light sensor and filter combination that approximates the
CIE eye-response curve.
2. The dominant wavelength (λd) is derived from the CIE chromaticity diagram and represents the
single wavelength which defines the color of the device.

Please read the following notes before using the datasheets:
1. Over-current-proof
Customer must apply resistors for protection, otherwise slight voltage shift will
cause big current change ( Burn out will happen ).
2. Storage
2.1 Do not open moisture proof bag before the products are ready to use.
2.2 Before opening the package, the LEDs should be kept at 30℃ or less and 90%RH or less.
2.3 The LEDs should be used within a year.
2.4 After opening the package, the LEDs should be kept at 30℃ or less and 70%RH or less.
3. Soldering Condition
3.1 Pb-free solder temperature profile.
3.2 Reflow soldering should not be done more than two times.
4. Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than 260℃ for 5 seconds
within once in less than the soldering iron capacity 25W. Leave two seconds and more
intervals, and do soldering of each terminal. Be careful because the
damage of the product is often started at the time of the hand solder.
5. Repairing
Repair should not be done after the LEDs have been soldered. When repairing is unavoidable,
a double-head soldering iron should be used. It should be confirmed beforehand whether the
characteristics of the LEDs will or will not be damaged by repairing.

Choose DOUBLE LIGHT, your expert LED components nearby!

Advantage:

• Over 10 years work experience technical service team
• Manufacturer direct sale,high quality product and competitive price
• Mix order accepted and free sample
• Make double check strictly and packing carefully.
• We will refund you in case of bad quality issue happens due to our product itself.